1- First, pass the four-sided axis A through the lock hole with its oval groove facing down and adjust its distance from both sides of the door.
2- Then place the plastic guide cartridge B on the four sides and then place the rosette base number C on the plastic cartridge.
3- Now locate the mounting screws D on the door and remove the plastic piece.
4- Use guide piece B (plastic cartridge) to carefully install the door on both sides to avoid any deviation.
5- The four sides of the door should be the same, and finally install the rosette and handle E on the rosette base and tighten the cap screws F under the handle and under the rosette with an Allen wrench G.
6- If there is an error or deviation in the installation of D-pins, use H-pins and nuts.
1- First, place cylinder A in its place and place plastic cartridge B on the cylinder so that its middle protrusion is separated.
2- Then place the rosette base C on the plastic piece B.
3- Use guide piece B (plastic cartridge) to carefully install the door on both sides to avoid any deviation.
4- Now locate the mounting screws number D on the door and remove the plastic piece.
5- The cylinder should be the same on both sides of the door. Finally, install the switch rosette number E on the rosette base and tighten the nut under the rosette F with the Allen wrench G.
6- If there is an error or deviation in the installation of the D screws, use the H screws and nuts.
